IC3D-KAPTON120-Polyimide-Tape-for-3D-Printer-Platforms-47W-0
IC3D-KAPTON120-Polyimide-Tape-for-3D-Printer-Platforms-47W-0IC3D-KAPTON120-Polyimide-Tape-for-3D-Printer-Platforms-47W-0-0IC3D-KAPTON120-Polyimide-Tape-for-3D-Printer-Platforms-47W-0-1

IC3D KAPTON120 (Polyimide) Tape for 3D Printer Platforms, 4.7″W

$17.99

Provides excellent bed adhesion for 3D printing with ABS and PLA
Enough to tape your 8″ glass sheet about 20 times
Easier application than a single 8″ wide sheet

Buy product

Category:

Product Description

This is a 120 mm (4.7″) wide by 10m long roll of kapton tape (polyimide). Enough to cover about 20 8×8″ glass sheets. We prefer this size since it’s easier to apply than full width sheets. Printing over heated kapton taped glass allows for excellent adhesion of melted plastic and gives the bottom of your print a nice smooth finish. After many hours of printing, refresh your printing surface with this stuff. This tape can handle temperatures of up to about 280c. We’ve tested tape from several different manufacturers and chose the best. Application tip: to minimize the seam from laying to sides down, just spray some lightly soaped water onto the glass and tape. Lay the first side down, slide to position, then squeegee the water out. Respray the second side if necessary, lay down the tape, slide to position to butt up against the first side, slowly squeegee out water. Let dry and trim off the sides.
Provides excellent bed adhesion for 3D printing with ABS and PLA
Enough to tape your 8″ glass sheet about 20 times
Easier application than a single 8″ wide sheet

Reviews

There are no reviews yet.

We want your opinions